Enclosure (3) to COMDTINST 4105.7
applicable support documents. Describe the method used to obtain replacement parts,
assemblies and equipment. Items should be listed to the LRU.
6.2.3
Depot/ICP Level. Identify the Depot and Inventory Control Point (ICP) for spare parts
and reference applicable support documents.
6.2.4 SMEF Level. If applicable, identify any spares consistent with the maintenance concept
for this level. This may include spares for installed engineering and support baseline
systems. List items to Lowest Repairable Unit (LRU).
6.3
Other Government Agencies. If spares or parts are available or supported in whole or in
part by other Government agencies or the Federal Supply System (FSS) state the agency
and parts, assemblies or equipment. For items from the FSS, identify source of supply
and National Stock Number (NSN). Include Acquisition Advice Codes (AAC).
6.4
Commercial Sources. Identify any commercial repair sources used for maintenance and
repair of the equipment. Provide manufacturer or distributors complete name, address,
telephone number, POC, CAGE and any GSA schedules or contracts. Provide general
terms and requirements of the intended maintenance contract and identify who will
administer the contract.
6.5
Delivery Locations. Identify where the "A" condition (ready for issue) asset will be
delivered (e.g., ELC, MLC, individual units, etc.)
6.6
Targeted Support Dates. Identify when support will be available for each level of supply
support. It is vital that support be available to units at time of installation. Include
warranty information and, if required, Interim Support Plan (ISP).
SECTION 7.0 - MAINTENANCE SUPPORT
7.1
Maintenance Support Concept. Describe the overall maintenance philosophy for the
equipment. The maintenance philosophy for the equipment must be consistent with the
maintenance concept identified in the ILSP for the end-item system.
7.2
Maintenance Requirements. Describe the maintenance requirements, consistent with the
maintenance philosophy identified in the ILSP for the end-item system, for the following:
7.2.1
Organizational Level. Describe the organizational level maintenance philosophy for the
equipment. Identify who will maintain the equipment, approximate Maintenance Man-
Hours (MMH), number of personnel and required personnel qualifications.
7.2.2
Intermediate Level. Describe the intermediate level maintenance philosophy for the
equipment. Provide the same information as in other levels of maintenance.
7.2.3
Depot/ICP Level. Describe the depot-level maintenance philosophy for the equipment.
Provide the same information as in other levels of maintenance.
7.2.4 SMEF Level. Describe the SMEF-level maintenance management philosophy for the
equipment. Provide the same information as in other levels of maintenance.
6
Previous Page
