COMDTINST 4000.12
CHAPTER 5. OTHER ILS AND PROGRAM SUPPORT ELEMENTS
A.
Training. No official unit training is envisioned at this time. A Users Guide, providing
equipment set up and operating instructions, has been developed by Commandant (G-ELM)
and will be distributed to each CG unit with receipt of their bar code equipment.
INTERMEC will provide computer training for the EECEN programmer, in accordance
with the contract. There is also limited bar code instruction via Knowledge Support
Software (KSS) distributed with SCAMP.
B.
Manpower and Personnel. One additional contract person will be required to work on the
bar code interface software initiative at EECEN. This position will be funded by
Commandant (G-ELM).
C.
Packaging, Handling, Storage & Transportation (PHS&T). The contractor will prepare
bar code equipment for packaging, handling and shipment. This equipment will initially be
shipped to Supply Center Baltimore (SCB) and SCB will then distribute the equipment to
each CG unit. The software developer at EECEN will prepare the packaging, handling and
transportation of all software to each CG unit supplied with bar code equipment.
D.
Technical Data. All hardware and embedded software technical data will be maintained by
INTERMEC. Application software technical data will be maintained by EECEN.
E.
Configuration Management. Application software Configuration Management will be
conducted by the SCAMP Configuration Control Board (CCB). The CMPlus CCB will
perform software configuration management for CMPlus.
5-1
Previous Page
